Home / Compatibility
CompatibilityWhat fits which Starlink
Every mount in this range is built around the dish's own 1.5 inch pipe thread, which is what the Standard (Gen 3) and Mini share. Here is the model-by-model answer, including the two dishes we do not fit.
Compatibility at a glance
| Dish / device | Roof mount | Wall bracket | Tripod stand | Router bracket | Notes |
|---|---|---|---|---|---|
| Starlink Standard (Gen 3 / V3 / Standard 4) | Yes | Yes | Yes | — | The 1.5" pipe thread both mounts and the tripod mast use. |
| Starlink Mini | Yes | Yes | Yes | — | Same thread, so the same mounts fit. Mini suits low-power and travel setups. |
| Starlink Gen 2 (rectangular, proprietary mast) | No | No | No | — | Gen 2 used a different mast fitting. Message us and we will tell you honestly what we can and cannot do. |
| Starlink Gen 1 (original round dish) | No | No | No | — | The original round dish predates the current pipe thread. Not a fit for this range. |
| Starlink Gen 3 router | — | — | — | Yes | The router bracket is made for the Gen 3 (Standard) router case specifically. |
| Starlink Mini router | — | — | — | No | Sized for the Gen 3 router. Email us if you are running a Mini. |
"Compatible with" means the part physically fits and works with that dish. Zatelitount is not affiliated with, endorsed by, or an official supplier to SpaceX or Starlink.
Why the interface matters more than the bracket
Starlink dishes do not screw onto a generic pole — they end in a specific 1.5 inch pipe thread, and a mount only works if it has that thread. Most third-party mounts get around it by making you buy a separate pipe adapter; we build the thread into the mount instead, so the dish goes straight on.
That is also why the answer is the same across the range: one interface, four ways to get the dish into open sky. Pick the mount by where you are installing, not by which dish you own.
Being straight about what does not fit
The Gen 2 rectangular dish and the original Gen 1 round dish used different mast fittings, so our current range does not fit them. We would rather put that in a table than have you find out after it arrives — message us with your model and we will tell you honestly.
And a note on naming: we describe our parts as compatible with Starlink, never as official Starlink hardware, because the second would be misleading. Independent hardware, clearly labelled.
Know your dish, but not your mount?
Common questions
Will this work with my Starlink dish?
Yes for the Starlink Standard (Gen 3 / V3 / Standard 4) and the Mini. Both use the same 1.5 inch pipe thread, which is the interface every mount here is built around.
Is Zatelitount official Starlink hardware?
No. We are an independent maker of installation hardware and we are careful to say so. Our parts are compatible with Starlink dishes; they are not made or endorsed by SpaceX.
Do I need the official Starlink pipe adapter?
No. The 1.5 inch pipe thread your dish mounts to is built into our roof mount, wall bracket and tripod mast, so the official adapter is not needed to make the two meet.
What about the older Gen 2 dish?
It used a different mast fitting, so our current range does not fit it. Message us with your dish model and we will tell you straight, rather than sell you something that will not work.
Does the router mount fit the Mini router?
No - the router bracket is sized for the Starlink Gen 3 (Standard) router. It is a router bracket, not a dish mount.
How do I know which mount fits my situation?
Run the three questions in the Mount Finder, or read the guide for your scenario. Both end at one product or an honest 'you do not need one'.